Tesla Model Y Owners & Service Manuals

Tesla Model Y: Topping Up Windshield Washer Fluid

The only reservoir into which you can add fluid is the windshield washer fluid reservoir, which is located behind the front trunk. When the level is low, a message displays on the instrument panel.

To top up the washer fluid:

1. Open the hood.

2. Clean around the filler cap before opening it to prevent dirt from entering the reservoir.

3. Open the filler cap.

4. While avoiding spilling, fill the reservoir until the fluid level is visible just below the filler neck. The reservoir has a capacity of 4.5 liters.

Topping Up Windshield Washer Fluid

5. Wipe up any spills immediately and wash the affected area with water.

6. Reinstall the filler cap.

NOTE: Some national or local regulations restrict the use of Volatile Organic Compounds (VOCs). VOCs are commonly used as antifreeze in washer fluid. Use a washer fluid with limited VOC content only if it provides adequate freeze resistance for all climates in which you drive Model Y.

CAUTION: Do not add formulated washer fluids that contain water repellent or bug wash. These fluids can cause streaking, smearing, and squeaking or other noises.

WARNING: In temperatures below 40º F (4º C), use a washer fluid with antifreeze. In cold weather, using a washer fluid without antifreeze can impair visibility through the windshield.

WARNING: Windshield washer fluid can irritate eyes and skin. Read and observe the instructions provided by the washer fluid manufacturer.

    READ NEXT:

     Jacking and Lifting

    Jacking Procedure Follow the steps below to lift Model Y. Ensure that any non-Tesla repair facility is aware of these lifting points. 1. Position Model Y centrally between the lift posts. 2. Positio

     Parts and Accessories

     Parts, Accessories, and Modifications

    Use only genuine Tesla parts and accessories. Tesla performs rigorous testing on parts to ensure their suitability, safety, and reliability. Purchase these parts from Tesla, where they are professi

    SEE MORE:

     Programming HomeLink

    To program HomeLink: 1. Park Model Y so that the front bumper is in front of the device you want to program. CAUTION: Your device might open or close during programming. Therefore, before programming, make sure that the device is clear of any people or objects. 2. Check that the device's remote co

     Range Assurance

    The driving range displayed in Model Y is an estimate of the remaining battery energy based on EPA-rated consumption. It may not account for your personal driving patterns or external conditions. The displayed range on the instrument panel may decrease faster than the actual distance driven. NO

    © 2019-2025 Copyright www.temoy.org