Tesla Model Y: Checking Brake Fluid
WARNING: Contact Tesla immediately if you notice increased movement of the brake pedal or a significant loss of brake fluid. Driving under these conditions can result in extended stopping distances or complete brake failure.
A red brake indicator on the
instrument
panel alerts you if the quantity of fluid in
the brake reservoir drops below the
recommended level. If it displays while
driving, stop as soon as safety permits by
gently applying the brakes. Do not
continue driving. Contact Tesla
immediately.
Topping Up the Brake Fluid
Do not top up your brake fluid. The following instructions are provided for information purposes and future reference only:
1. Clean the filler cap before removing it to prevent dirt from entering the reservoir.
2. Unscrew the cap and remove it.
3. Top up the reservoir to the MAX mark using the appropriate brake fluid.
4. Reinstall the filler cap, ensuring it is fully secured.
WARNING: Only use new fluid from a sealed air- tight container. Never use previously used fluid or fluid from a previously opened container-fluid absorbs moisture which decreases braking performance.
WARNING: Brake fluid is highly toxic. Keep containers sealed and out of the reach of children. In the event of accidental consumption, seek medical attention immediately.
CAUTION: Brake fluid damages painted surfaces. Immediately soak up any spills with an absorbent cloth and wash the area with a mixture of car shampoo and water.
READ NEXT:
Topping Up Windshield Washer
Fluid
The only reservoir into which you can add fluid is the
windshield washer fluid reservoir, which is located
behind the front trunk. When the level is low, a message
displays on the instrument panel.
Jacking and Lifting
Jacking Procedure
Follow the steps below to lift Model Y. Ensure that any
non-Tesla repair facility is aware of these lifting points.
1. Position Model Y centrally between the lift posts.
2. Positio
SEE MORE:
Installing and Using a Carrier
When using the tow package to carry accessories, the 2" x 2" (5 cm x 5 cm)
square hitch receiver is designed to support vertical loads of up to 160 lbs (72
kg). Ball mounts that are compatible with the square receiver must be purchased
separately.
To install and use an accessory carrier, you must
Canceling and Resuming
To manually cancel Traffic-Aware Cruise Control, press the brake pedal or
briefly move the drive stalk up once. The cruising speed icon on the touchscreen
turns gray to indicate that Traffic-Aware Cruise Control is no longer active.
WARNING: Do not hold the drive stalk up for more than one second.
