Tesla Model Y Owners & Service Manuals

Tesla Model Y: Park

Press the end of the drive stalk while Model Y is stopped.

Park

Model Y automatically shifts into Park whenever you connect a charge cable or if two or more of the following conditions are met simultaneously while traveling slower than approximately 1.5 mph (2 km/h):

  • The driver's seat belt is unbuckled.
  • The occupancy sensor in the driver's seat does not detect an occupant.
  • The driver's door is opened.

To make it convenient to pick up passengers, you can also unlock all doors at any time by shifting into Park then pressing the Park button a second time.

NOTE: You must press the brake pedal to shift out of Park.

NOTE: The above conditions do not reflect a comprehensive list of reasons why Model Y may or may not automatically shift into Park and, in certain scenarios, it is possible for your vehicle to shift into Park when only one of the above conditions is true.

CAUTION: Model Y will not shift out of Park if the front trunk is not securely shut or if the charge port is unable to determine whether a charging cable is plugged in. Ensure the front trunk is closed and any charging cables are unplugged, and follow the directions on the touchscreen to proceed.

WARNING: In emergency situations, if the brakes are not functioning properly, press and hold the Park button on the drive stalk to bring the vehicle to a stop. Do not use this method to stop the vehicle unless absolutely necessary.

WARNING: It is the driver's responsibility to always ensure the vehicle is in Park before exiting. Never rely on Model Y to automatically shift into Park for you; it might not work in all circumstances (for example, if Creep or a slope causes the vehicle to travel greater than approximately 1.5 mph (2 km/h) ).

    READ NEXT:

     Lights

     Controlling Lights

    Touch Controls > Lights on the touchscreen to access all light controls, both interior and exterior. You can also pull the turn signal stalk toward you to display a popup that provides quick acce

     High Beam Headlights

    By default, Auto High Beam is enabled to allow high beam headlights to automatically switch to low beam when there is light detected in front of Model Y (for example, from an oncoming vehicle). To c

    SEE MORE:

     Operating Summon with the Key Fob

    NOTE: Summon may not operate if the battery is low on the key fob. Follow these steps to park Model Y from outside the vehicle using the key fob: 1. On the touchscreen, ensure that Require Continuous Press is disabled (touch Controls > Autopilot > Customize Summon > Require Continuous

     Adding Stops to a Route

    After you have entered a destination, you can edit your route by adding, deleting or reordering stops. Touch the three dots at the bottom of the turn-by-turn direction list to view options to edit your route. Add Stop allows you to add a stop by searching for a location or adding a Home, Rece

    © 2019-2025 Copyright www.temoy.org